Oversized Fasteners

Presolicitation Synopsis Oversized Fasteners for the Falcon 2020 Process Short Title: Oversized Alcoa Fasteners B100-ETU14-XX Solicitation # F8224-16-R-0023 NOTICE OF INTENT TO SOLE SOURCE: This is a pre-solicitation synopsis in accordance with FAR 5.201. This is not a Request for Proposal (RFP) or an Invitation for Bid (IFB), nor is it to be construed as a commitment by the government. This synopsis is prepared in accordance with guidance found in FAR 5.207, and is prepared for the purpose of notifying potential offerors of an upcoming solicitation for service or supplies. The solicitation for this requirement will be posted under the same reference number as stated above. It is the contractor's responsibility to monitor FedBizOpps on a regular basis for the solicitation along with any amendments. The Ogden Air Logistics Complex (OO-ALC), Specialized Contracting Office (PZIMB), intends to negotiate with Alcoa Fastening Systems & Rings, on a sole source basis under the authority of 10 USC 2304(c)(1), as implemented by FAR 6.302-1. Only one responsible source and no other supplies or services will satisfy agency requirements, to procure the following NON-STOCK LISTED PARTS FOR THE F-16 Horizontal Stab ASIP Repair Project RCN FT-2013-004: QTY PART NUMBER NOMENCLATURE 100 EA B100-EUT14-10 Blind Bolt Fastener, High Strength Pull Type, Positive Mechanical Lock 100 degrees Flush Head 100 EA B100-EUT14-11 Blind Bolt Fastener, High Strength Pull Type, Positive Mechanical Lock 100 degrees Flush Head 100 EA B100-EUT14-12 Blind Bolt Fastener, High Strength Pull Type, Positive Mechanical Lock 100 degrees Flush Head 100 EA B100-EUT14-20 Blind Bolt Fastener, High Strength Pull Type, Positive Mechanical Lock 100 degrees Flush Head 100 EA B100-EUT14-21 Blind Bolt Fastener, High Strength Pull Type, Positive Mechanical Lock 100 degrees Flush Head 100 EA B100-EUT14-22 Blind Bolt Fastener, High Strength Pull Type, Positive Mechanical Lock 100 degrees Flush Head Alcoa Fastening Systems & Rings 3990A Heritage Oak Court Simi Valley California 93063. The Falcon 2020 process requires engineering Requests (EPRs) to be submitted to Lockheed Martin for their approval when a repair to a F-16 does not follow standard Technical Orders (T.O.). Supply Chain Engineers and repair shops are only permitted to follow what Lockheed Martin has approved for the end items. USAF Supply Chain Engineering regarding this repair submitted an EPR to Lockheed Martin and Lockheed Martin approved Alcoa fasteners B100-EUT14-XX could be used in the oversized holes. The 202 engineering disposition provides the shop the authority to complete the EPR, thus approving the 533rd CMMXS/MXDXA to use the Alcoa fastener and only the Alcoa Fastener on the F-16's. The solicitation will be posted under the same number FA8224-16-R-0023 on FedBizOps during the month of January 20, 2016. Please submit any questions concerning this requirement in writing to all listed below: Contract Specialist AFMC AFSC OL:H/PZIMB DAVID BRYAN 6038 ASPEN AVE B1289 2nd Floor HILL AFB UT 84056-5805 TEL: 801-777-5486 [email protected] Contract Officer: AFMC AFSC OL:H/PZIMB DAVID BRYAN 6038 ASPEN AVE B1289 2nd Floor HILL AFB UT 84056-5805 TEL: 801- 586-7779 Email: [email protected]