1. SOURCES SOUGHT ANNOUNCEMENT FOR LASER SERVO A. INTRODUCTION 1. This is a Sources Sought synopsis being conducted pursuant to FAR Part 10, Market Research. This is for planning purposes only and there is no solicitation available at this time. 2. This is an initial step in the planning process for a Laser Servo Controller with power supply. The Government is contemplating award of a Firm Fixed Price contract. 3. AFRL/RVBY, seeks potential sources to provide the specific required equipment for a Laser Servo Controller and power supply at Kirtland AFB, NM. 4. The North American Industrial Classification Systems (NAICS) code is 333314, Optical Instrument and Lens Manufacturing, which has a small business size standard of 1000. B. INFORMATION AND INSTRUCTIONS: 1. All businesses capable of providing this equipment are invited to respond. Any information provided to the government as a result of this sources sought synopsis is voluntary and the Government will not pay for any information submitted. Respondents are requested to submit capability statement electronically, as described below. a. Requested information listed below must be received no later than 1100 hours (Mountain Standard Time) on 21 March 2016. b. Information package responses shall be sent via email to
[email protected]. c. Statement Package: Respondents must include the following information 1. Company name 2. Address 3. Point of contact with e-mail address and telephone number 4. Federal CAGE Code 5. Data Universal Numbering System (DUNS) 6. Category socio economic C. GOVERNMENT RESPONSIBILITY: This Sources Sought Notice is not a solicitation, and should not be construed as a commitment by the Government for any purpose, nor does it restrict the Government to an ultimate acquisition approach. Any information submitted by respondents to this sources sought is strictly voluntary and any offer submitted by such a firm will be evaluated without prejudice. All questions and comments on this notice shall be submitted via e- mail to only the contact listed below. PRIMARY CONTACT: Ms. Virginia Garcia (505-846-2917), Contract Specialist,
[email protected]. D. REQUIREMENTS: Preference for this system would be to have the following components working together from one manufacturer with all the same interfaces. Any system MUST MEET or EXCEED these requirements: 1. Laser Servo Controller a. Five (5) laser servo control systems b. The servo system should include two integrators, delivering PI²D loop control c. The proportional gain must have a minimum tunable range of -37 dB to +29dB d. The first integrator must have a tunable range >100kHz e. The second integrator must have a tunable range >1MHz f. The differentiator must have a tunable range >10 MHz g. The differential must have a tunable range up to 12 dB *Must provide both a PZT and current feedback h. Must deliver high bandwidth >10 MHz i. Must deliver input voltage range > ± 0.25 V j. Must deliver an output voltage range > ± 5 V k. Must deliver an input impedance of 50 Ω l. Must deliver an input voltage noise < 10 nm/ √Hz 2. Power Supply a. Two power supplies capable of supporting 5 laser servo controllers b. Output regulation better than 0.1% c. Electronics should use a standard U.S. wall outlet: 120 V AC, 60 Hz 3. Additional Specifications a. Dynamic range i. P gain from -40 to +30 dBm ii. First integrator with a tunable range of 10 Hz to 150 kHz iii. Second integrator with a tunable range of 100 Hz to 1.5 MHz iv. Differential gain from 5 dB to 12 dB, with tunable range of 500 Hz to 5 MHz v. Must provide both a PZT and fast current feedback b. Frequency response characteristics i. <5 degree phase shift at 10 MHz c. Programmability i. Programmable from the front panel with switches or POTS d. Size, weight and power i. Overall dimensions <8"x9"x4" ii. Must weigh <5 lbs iii. Power supplied via 120 VAC