SMC B37506 MRF HVAC @ KIRTLAND AFB

The contractor shall furnish all parts, material, labor, equipment and supervision necessary to complete the work for FY-20 B37506 MRF HVAC . The work shall include the following requirements listed in the specific requirements and a target of 74 Degrees. Demolition Contractor shall prep B37506 for installation of mini-split unit. Existing ductwork to remain. Contractor shall remove existing furnace and prep for install of new heat pump air handling units. Construction Contractor shall use existing electrical panel and or provide subpanel, to supply power to new unit. This must be known in order to properly bid. Contractor shall provide and install (4) four - new 4-way mini-split cassettes, 24,000 BTU HVAC unit, PLFY-EP24NEMU-E or equal Contractor shall provide and install (4) four - new 4-ton AC condensers, PUMY-P48NKMU1 or equal, condensers to be mounted on East and West exterior walls. Contractor shall provide and install (2) two - new heat pump air handling units. Modify existing ductwork to new units and provide duct transition. Contractor shall provide and install condensate lines and line sets to new air handling units and cassettes. Perform 600 psi 24-hour leak check. Perform 500 micron 1-hour check with vacuum pump off. Contractor shall provide a test and balance of new system. Contractor shall plug roof vent openings and other openings as needed SOW does not include the following: Gas, plumbing, drywall, plaster and concrete Roof or ground penetrations Ceiling/tile replacement, lighting and roofing Engineering