Building 37068 & 37075 Camargo Bunkers

This action was awarded as and 8(a) Sole Source Set-Aside under the authority of section 8(a) of the Small Business Act. SOW: a. Building 37068: 1. The contractor shall remove the existing 70 amp panel on the exterior of the bunker and replace with a new exterior 100 amp Service panel. 2. Contractor shall refeed the existing circuits and add the new as per the SOW. 3. The contractor shall install 5 dedicated receptacles 120v to the internal storage bunkers. Receptacles shall be installed at locations provided by the user and in accordance with code. (two on the North and South walls and one on the East wall). 4. Contractor will need to core drill two 2” holes and install a pull box on each penetration. The penetrations shall be sealed from the elements. 5. Contractor will run two ¾” ridged conduits through the new core drills to feed the receptacles in the bunker. Conduits shall be fastened to the concrete ceiling and walls. (~400 lf) 6. Contractor will need to install metal receptacle boxes, duplex receptacles and metal face plates. b. Building 37075: 1. The contractor shall install 6 dedicated receptacles 120v to the internal storage bunkers. Receptacles shall be installed at locations provided by the user and in accordance with code. (two on the North and South walls and one on either side of the door on the West entrance). 2. Space is available in the existing power panel. 3. Contractor will utilize existing penetrations inside the bunker to pull the ridged ¾” conduits. Conduit shall be fastened to the concrete ceiling and walls (~400 lf). Penetrations shall be sealed once ridged conduit is installed. 4. Contractor will need to install metal receptacle boxes, duplex receptacles and metal face plates.