DRYDOCK REPAIRS - USCGC NEAH BAY

The United States Coast Guard is considering whether or not to set aside an acquisition for HUBZone concerns, Service-Disabled Veteran-Owned Small Business Concerns (SDVOSB) or for small businesses. The small business size standard is less than 1,000 employees. The NAICS Code is 336611. The acquisition is for DRYDOCK REPAIRS of the USCGC NEAH BAY (WTGB 105). The USCGC NEAH BAY (WTGB 105) homeport is the CLEVELAND, OH. GEOGRAPHICAL RESTRICTIONS- THE GREAT LAKES AREA. Anticipated start date on or about 08 MAY 2013 through 26 JUNE 2013. The scope of the acquisition is to: (1) Hull Plating ( U/W Body ) , Inspect; (2) Hull Plating ( U/W Body ) Ultrasonic Testing , (3) Bubbler Channels, Inspect; (4) Appendages (U/W) Leak Test, -( 5) Bubbler; Preserve (6) Propulsion Shaft Rope Guards, Inspect and Repair,; (7) Appendages (U/W) - Internal, Preserve; (8) Tanks (Ballast), Clean; (9) Propulsion Shafting; Remove, Inspect and Reinstall; (10) Shaft seal Assembly, Overhaul; (11) Propulsion Shafting Bearing (External); Remove, Inspect and Reinstall; (12) Propeller, Remove, Inspect and Reinstall; (13) Fathometer Transducer, Renew, (14) Sea Valves and Waster Pieces, Overhaul or Renew; (15) Fuel Valves, Overhaul or Renew; (16) Rudder Assembly, Remove, Inspect and Reinstall; (17) Rudder stock Bearing, Check clearances; (18) Tanks (Ballast) Preserve 100%, (19) Tanks (Ballast) Preserve Partial; (20) U/W Body, Preserve 100%; (21) Hull Plating Freeboard, Preserve, (22). Drydocking; (23). Temporary Services, (24). Watertight Doors and Scuttles (External), Renew; (25). Deck covering (Wet Dry), Seal; (26). Tanks (MP Fuel Service), Clean and Inspect; (27). Propulsion Shafting, Thrust Bearing Measurement; (28). Rudders, Preserve; (29). Tanks (Grey Water Holding), Preserve; (30) Stern Tube Interior Surfaces, Preserve. (31) Tanks (grey Water Holding), Clean; (32). Fuel Manifold, Overhaul; Lower Motor Room, Abate Lead and Asbestos-Containing Coatings; (33) BOS'N Hole (deck), Abate Lead Coating, and (34) Seal Trial Performance All welding and brazing shall be accomplished by trained welders who have been certified by the applicable regulatory code performance qualification procedures. In accordance with FAR 19.1305, if your firm is HUBZone certified or FAR 19.1404, if your firm is SDVOSB or a small business concern and intends to submit an offer on this acquisition, please respond by e-mail to [email protected] or by fax (757) 628-4676. Questions may be referred to Sandra Martinez at (757) 628-4591. In response, please include the following: (a) a positive statement of your intent to submit a bid for this solicitation as a prime contractor; (b) evidence of experience in work similar in type and scope to include contract numbers, project titles; dollar amounts, points of contact and telephone numbers; (c) past performance references with points of contact and phone numbers. At least two (2) references are requested, but more are desirable. Contractors are reminded that should this acquisition become a HUBZone set aside or SDVOSB Small Business, FAR 52.219-3, Notice of Total HUBZone Set-Aside or 52.219-27 or Notice of Total Service-Disabled Veteran-Owned Small Business Set-Aside will apply, which requires that at least fifty (50) percent of the cost of personnel for contract performance be spent for employees of the concern or employees of other HUBZone small business concerns. Your response is required by close of business on November 21, 2012. All of the above must be submitted in sufficient detail for a decision to be made on a HUBZone, Service-Disabled Veteran-owned Small Business set aside, small business set aside. Failure to submit all information requested may result in no set-aside. A decision on whether this will be pursued as a HUBZone, SDVOSB small business or a Small Business set aside will be posted on the FedBizOps website at http://www.fbo.gov