Z -- WILLMETTE, ILLINOIS REPLACE EXTERIOR DRAINAGE SYSTEM AT USCG STATION WILMETTE

Provide all necessary labor, materials, equipment, supervision and transportation required to replace drainage system, repair water damaged interior walls and install a new HVAC system in the basement at U.S. Coast Guard Station Wilmette, Wilmette, IL.Remove and replace the lay-in acoustical ceiling in the training room. Revise the ceilings to accommodate new HVAC equipment. Remove the existing wall coverings in the training room and finish the existing cement block walls. Provide new openings in walls required for ventilation, supply and exhaust duct penetrations. Patch abandoned openings. Remove fasteners, stains and repair damage associated with removal of wall finishes and equipment. Install replacement walks, lawns, planting beds and ornamental plants to duplicate the existing landscape. Block, fill and paint masonry walls in training room. Demo indicated baseboard radiation and associated piping in the training room. Install a DX, hot water air handling unit in the mechanical room to serve the training room with a remote grade level condense unit. Install a wall mounted exhaust fan serving the training room. Demo and replace the existing ductwork in the training room with new ductwork. Install ventilation and exhaust louvers, fans and ductwork. Install supply and return ductwork. Install new footing level storm water drainage near the foundation of the existing basement walls. Demo existing drain tile and piping as required to complete new work. Install new storm water piping and modified roof downspout pipes (leaders) into new roof storm drains. Install a new trench drain with gravel catch basin at entrance to boat house and connect into roof storm drain. Install storm drain cleanouts, outfalls and connections as shown on drawings. Waterproof and damp-proof the existing masonry walls exposed by the footing drain construction and as indicated on the drawings. Prevent frost damage through use of straw or insulating temporary fills. Revise existing hydronic piping to accommodate new equipment. Install a low voltage temperature control system and line voltage power for the mechanical equipment installed. Install new ceiling diffusers and grills. Provide temporary ventilation during removal of mold damaged materials in the training room. Provide power for new HVAC units, and controls. Demo indicated existing electrical on training room walls. Provide temporary power, and miscellaneous revisions to wiring. Install new electrical work on training room walls as shown.